Hours: 8-4 Monday thru Saturday

Driveway Preparation for "GILSONITE" Weather Sealer: I clean the driveway with a power blower and broom. This helps remove dust and dirt trapped in small cracks. For proper adhesion, the surface must be dust free. I edge your driveway and remove grass, weeds from the cracks, etc. Sweep the driveway again and blow off all dust. Fill all large cracks and holes with the appropriate filler. Mask off all painted surfaces to prevent over spray of sealer. Steps, doorways, light posts, garage entrances, etc. Driveway sealer will be sprayed on by high pressure to ensure coverage and penetration of asphalt pores and minor cracks. When sprayed asphalt surfaces have been finished, a caution tape or barrels will be placed just before the entrances to your driveway (walkway). Etc. In the event it should rain. You do not have to worry about the sealer washing away. The "GILSONITE" sealer is waterproof even though it hasn't completely dried. The drying time for the sealer is any where between 3 to 5 hours for walking on, depending on the temperature and humidity. I recommend that you don't drive on the sealed surface for at least 12 hrs. The warmer the weather is out the quicker the sealer dries. You may encounter small puddles of sealer at the beginning of the seal coating and in very tight situations in which it is hard to reach with the pressure spray gun. These situations will be kept to a minimum. Don't worry the sealer will dry, the puddles take a little longer to dry. You can tell if the sealer has dried by touching the surface with your fingertips. If it feels tacky it has not dried yet! The asphalt surface must be completely free of all water. This sealer can not he mixed with water Small wet areas can be dried with the power blower!

This is a "GILSONITE" asphalt rejuvenating sealer. All workmanship and materials guaranteed for one full Year!